No or Low Force During Splitting
Cause:1- The nut /57 M40 x 1.5 is loose2- Clutch spring is deformed Solution:1- Increase the play and tighten the round nut /57 M40 x 1.52- Replace the clutch spring
Engagement Clutch Noise
Problem1- The clutch play is too small2- The clutch is not fully disengaged SolutionAdjust the clutch play or replace the clutch spring
What Should I Do If One of My Wheels Is Loose?
There are two things you can do if a wheel is loose: Tighten the Bolt – To do this, refer to the “Tighten and Lubricate Wheel Bearings” section of your user manual. Check for a Damaged Bearing – If present, replace it.
What Can I Do If My Blade Comes Off the Wheels?
Several factors can cause this problem:
Why Won’t My Winch Cable Go Up or Down?
There are two possible causes: either the winch solenoid is defective, or the winch itself is defective. And if it doesn’t stop automatically when the cutting head is fully raised or lowered, what could it be? The main cause of this problem is a defective limit switch (microswitch) on the winch.