Clutch slipping
Causes: Solutions:✓ Sharpen or replace the blade✓ Clean the clutch housing✓ Inspect/repair clutch springs and shoes
Engine stalls / loses RPM
Causes: Solutions:✓ Slow your feed rate✓ Clean/replace the air filter✓ Sharpen/replace the blade
How do I get help if my machine has an issue?
Start by contacting your dealer. They can diagnose issues, order parts, and handle warranty claims.
After How Many Hours of Use Should I Perform Maintenance on My Sawmill?
Maintenance, including lubrication, should be performed at least every 40 hours of operation. The first engine oil change should be done around 20 hours of use or after the first month, whichever comes first. After that, it should be done every 100 hours or every 6 months. We recommend referring to the “Maintenance Schedule” section […]
Why Does My Engine Crank But Not Start?
Several factors can cause this issue:
I Don’t Have Enough Pressure (or Not Enough) in the Hydraulic Tensioner – What Can I Do?
Check the Hydraulic Oil LevelIf it is too low, add hydraulic oil. Check for Micro-Leaks in the Tensioner Hydraulic SystemA good way to identify a possible leak is to look for small sawdust balls. Their position indicates the location of any micro-leaks, if present. Tensioner Seal May Be DefectiveReplace it if necessary.
What Should I Do When the Blade Guide Wheel Spins Poorly or Not at All?
It is very likely that your blade guide bearing is worn or defective. Replacing the bearing should solve your problem.
Engine Does Not Start
Cause:1- Check the gas level2- Check the oil level3- Check fuel ON/OFF4- Check ON/OFF switch Solution:1- Add gas2- Add oil3- Refer to the engine manual
Thrust Plate Cannot Retract or Retracts Slowly
Cause:1- Wood chips or debris under the thrust plate2- Return spring is too loose Solution:1- Remove debris from under the thrust plate2- Apply oil to the assembly3- Adjust or replace the return spring
Thrust Plate Retracts Too Quickly
Cause:Return spring is too tight Solution:Adjust or replace the return spring