Blade comes off band wheels
Possible causes: Solutions:Same as above:
Blades break
Possible causes: Solutions:
Blade slows down or stops while milling
Possible causes: Solutions:
Mill does not cut / cuts very slowly
Possible causes: Solutions:
Mill vibrates excessively
Possible causes: Solutions:
What should I do when my saw is not spinning fast enough / not spinning at all?
Check that the saw valve is engaging properly – replace if needed. Check that the safety valve opens and closes correctly – replace if needed.
What should I check if the splitter has no pressure?
Check that the saw valve is engaging properly – replace if needed. Check that the safety valve opens and closes correctly – replace if needed. Check the splitter relief valve and adjust the pressure as needed.
Mill does not cut square
Causes: Solutions:✓ Reduce dog pressure✓ Level the track✓ Re-adjust cables✓ Re-adjust blade guides✓ Ensure the flat cant face sits flush against the squaring post✓ Replace carriage wheel
The blade dips or rises
Causes: Solutions:✓ Sharpen or replace the blade✓ Saw at full RPM✓ Check the torque on the tension bolt✓ Perform a “flutter test”✓ Use blade lubricant⚠️ DO NOT USE petroleum products, mineral oil, or vegetable oil on our mills✓ Saw the log from the top down (small end to large end)✓ Slow down feed rate✓ Reset […]
Hardwood milling issues
Causes: Solutions:✓ Always saw at full RPM✓ Adjust belt tension✓ Slow down your feed rate✓ Sharpen or replace the blade✓ Clean the wheels and track